Чтобы все понимали уровень китайского качества, прежде чем потратят на это деньги.

https://www.reddit.com/r/MouseReview/comments/1plgia7/rapoo_vt3_max_gen2_reviewgood_battery_and_build/

I'll be using the Dav3 wired as a comparison since these two mice are similar in shape. The sensor of the Rapoo is nowhere near as good as the Dav3 wired.

Positives:

The shape is better than the Deathadder V3 wired. Shorter than the Dav3 and this makes it more manageable to hold and allows more palm on the mouse.

The right side doesn't flare out like the Dav3. This allows the ring finger to be more straight when holding the mouse if you use a palm grip.

It is better for claw/claw+palm grip because the right side is flatter.

LMB and RMB aren't as light as the Dav3 which I prefer. RMB feels lighter though.

Very light clicks for the side buttons and these have a gap in between which makes it easier to click the buttons.

Good battery and doesn't go under 30% for a week on the highest settings.

Negatives:

The mouse skates are horrible. It is so thin that the mouse is scratching the mousepad.

Design flaw on the underside of the mouse. The bottom of the mouse is not flat and this scrapes the mousepad. Applying weight makes it worse.

Scroll wheel has less defined steps so feels very light.

Very rear heavy because of the battery location. If you have your palm on the mouse it will feel a lot heavier on the rear.

There seems to be some kind of inconsistent click latency because sometimes it feels responsive but there are also times where the clicks don't respond.

The worst thing about this mouse is the sensor:

There is some kind of lag in the sensor when moving the mouse. It feels very delayed.

When moving slower, the delay feels higher.

Sometimes the sensor feels floaty. This does not give a snappy or raw feeling so there's a lot of overshoot and undershoot when aiming.

The cpi feels slower than the Dav3. I was using 3150 cpi on the Dav3 wired and 0.17 to 0.19 sensitivity in CS2 while for the VT3 I'm need to use 3600 and 0.24.

There's a difference in the polling rate. The lower the polling rate the higher the delay it seems in the sensor. I needed to increase sensitivity when using 2k.

Rating 3/10. This mouse isn't for competitive gaming. The sensor does not perform as good as the Dav3 wired. Even though the shape of the Dave3 wired was horrible for me, I still was able to reach 20k in CS2 and when the cable stopped working I switched to my Intellimouse Pro and I was still at 19k. The 3310 sensor of the old Zowie EC1 feels even more responsive than this mouse.

EDIT: Forgot to mention that going to the BIOS settings this is so much laggier. Like 10x delayed.